Aim MXG User Manual download pdf (Page 8)

7.3 Speed Read from Wheel Sensors

MXG has four wheel speed inputs, one in

the 37 pin connector and the other three in

the 22 pin connector:

The digital sensor X05SNBS00 detects the

presence of a metallic tooth placed at a

distance between 0.5 and 2 mm.

Please use the software RaceStudio3 for

configuring the system.

Just enter the program configuration panel

and, after enabling the desired speed

channels, set the wheel circumference and

the number of pulses per revolution.

7. Speed

MXG can receive the speed signal from

three different sources:

n

From the ECU

n

From the GPS receiver included in the kit

n

From the four digital channels

It is, therefore, possible for MXG to receive

and store different values of speed at the

same time; the more powerful ECUs

transmit up to four wheel speed values.

7.1 Speed Read from ECU

If your ECU sends the value of speed in its

data stream, it is obviously possible to read,

record and show that value.

Simply enable use of the software

RaceStudio3, as explained in section 10.1.

7.2 Speed Read from GPS Receiver

The GPS receiver integrated in the MXG kit

is configured in order to obtain the best

performance in terms of reactivity and

accuracy.

For getting GPS speed, you don’t need any

configuration. Simply connect the GPS05

Module to your MXG, and after a setup

period of some seconds, the data will be

received and automatically recorded.

CHAPTER 7 SPEED

14 15

MXG

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Comments to this Manuals

No comments